PySide CMake Primer
PySide CMake Primer
This page is a basic introduction to CMake, the build system used by PySide and the bindings generator.
These practical steps will focus on how to use CMake on a Linux (or similar) environment but should apply with minor modifications to other supported platforms as well.
Configuring
Project file – CMakeLists.txt
CMake parses the file CMakeLists.txt for information about the project, like project name, dependencies, what should be compiled, what should be shipped, and so on.
CMake variables
CMake can have its default behavior modified by providing some options in the command line:
- CMAKE_INSTALL_PREFIX=<some path here> sets the install prefix to the specified path.
- CMAKE_MODULE_PATH=<some path here> sets the extra directories where CMake will try to find its modules. (Note that if there are cmake configuration files in the default module path, /usr/lib/, that cmake will use these first.)
- CMAKE_TOOLCHAIN_FILE=<file path> sets the path to the file that describes the toolchain used to compile this project. It is very useful when using CMake with Icecream to speed up compilation.
- SITE_PACKAGE=<some path here> sets the Python site-packages directory
You can define a variable using the -D<VARIABLE> switch like the example below.
- -DCMAKE_BUILD_TYPE=Release|Debug sets the building behavior. Default value is Release.
Invoking CMake
After writing the CMakeLists.txt and deciding which flags will be used, you can invoke CMake using:
For example, if you use the build/ folder to build the project and want it to be installed into /opt/sandbox/, use the following lines:
CMake will process the project file and write the output files in the current directory.
Building
After the configuration process, the Makefiles are written and you can build the project by issue the command
make
.
Installing
As in the building process,
make install
will install the files into the target directory.