Simple Crypt IO Device

From Qt Wiki
Revision as of 17:45, 14 January 2015 by Maintenance script (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Writing a Custom I/O Device with encryption via SimpleCrypt class

Creating a custom IO device was already described in Writing a Custom I/O Device. The encryption is used from Simple encryption with SimpleCrypt.

The example app can be found on gitorious: qtdevnet-wiki-mvc/qtdevnet-simplecryptiodevide [gitorious.org] .

Usage

The following code snippet shows how we would use the custom I/O device to encrypt data and store the result in a file:

The

compressionMode

and

Integrity Protection

can be changed if needed. Also, if needed, a signal

blockWritten

can be connected.

Implementation

The basic implementation is the same as in Custom I/O Device. The big difference is, that the data can’t be stored directly when the client writes it to the device, as the encryption/decryption is done block wise.

This means

readData

and

writeData

must be changed.

SimpleCryptIoDevice

has a property blockSize. Data that is written is stored in an internal buffer of size blockSize. When the buffer size is reached, the data is encrypted and stored. This is needed, as

SimpleCrypt

(in it’s used version) does not allow to encrypt to a stream.

Efficiency

Note that because

SimpleCrypt

uses a header and both the compression and the data protection hash or checksum are calculated and stored at the the block level, using

SimpleCryptDevice

in this form results in a larger output stream than when using the

SimpleCrypt

class directly. Perhaps a future version of

SimpleCrypt

will support a streaming interface to increase efficiency in use cases such as these.

readData

For reading, alway a complete block must be read from the device. Then the needed data is moved to the data buffer of the client. As there might be data left in the buffer, each read furst gets the data of the internal buffer. when it’s empty, new data is read from the underlying device.

The stored data always contains an int with the size of the encrypted buffer.

writeData

To write the data to the underlying device, first the current block needs to be filled. To achieve this, all data is attached to the buffer

m_byteBuffer

. unless the buffer is smaller than the block size, one block is removed of the buffer and stored in the underlying device. writing one block is fairly easy. The block is encrypted by a call to

SimpleCrypt::encryptToByteArray

and the size of the encrypted data and the data itself is written to the underlying device.

To ensure no data is left when the device is closed, during close or destructor, the last buffer is flushed to the device.

That’s all.

Example application screenshot

Example App

Categories: